Extractor 49

Application

• For all rolling bearing types. For extracting complete rolling bearings or tightly fitted inner rings. The extractor and the separating device are available in various sizes with openings of up to 210 mm.
• Especially for applications where the inner ring is adjacent to a shaft shoulder without extraction slots. The bearing location must be radially accessible without problems.
• If handled correctly, inner rings and complete rolling bearings are extracted without getting damaged

Operation

The two wedge-shaped halves of the separating device are inserted between shaft shoulder and inner ring by alternately tightening the nuts. The separating device is bolted to the extractor by means of two tie rods that are fastened on the extractor’s cross arm. The bearing or inner ring is extracted by screwing in the spindle. For parts that are located very deep on a shaft tie rod extensions can be supplied.